Now, Five sizes of Range Finder Bro's!

June 30, 2014

New sizing for our RangeFinder Bro's...

With manufacturer's always tinkering, we've decided to rearrange our sizes of RangeFinder Bros from just two sizes up to three.

As of July, 1st, we will offer three sizes of RangeFinder Bro's: Small, Medium and Large.

the "old" XS is now SMALL; The "new" Small is now Medium; And, the "old" SMALL is now LARGE. Dimensions are available soon.

That way we can accommodate 99% of the Range Finders manufactured that you would carry.

Remember, our Range Finder Bro is weatherproof and is ambidextrous--put it most any where accessible--belt loops, harness webbing you decide where!

Hope that helps....

Comments will be approved before showing up.

How to Measure Yourself

A. Chest

Measure around the chest and body at its fullest part (typically right under the armpits and shoulder blades, right across the nipples)
Hold the tape against the body tight enough so that it does not slip down, but not so tight that it restricts breathing. It should be “snug”
Make sure the tape is horizontal and the person’s arms are by their side; then take a normal breath and measure
Do not puff out your chest
Double check this measurement

B. Sleeve

Keep your elbow slightly bent
Measure from the end of the right shoulder to the “Pinch” of the right hand
The “Pinch” of the hand is found where the base of the thumb and the base of the index finger intersect (approximately 1 inch above the index finger knuckle)
Double check this measurement

C. Waist

Measure around your waist at the level where you would normally wear your pant’s belt
With the tape measure snug around your waist, relax, and take the measurement

D. Inseam

Measure from the lowest part of your crotch area to the floor
Make sure the tape is tight along the inside of your leg, that you are standing straight, and then measure
Do not wear shoes!